Grage Aeromodelling

Ilhamwrtm wrote:

danielronaldo23 wrote:Wah enak ya ada yang ngeracunin. Kalau saya ngeracunin diri sendiri. (Lah bunuh diri dong) hehehe

Jangan bunuh diri dong
Boleh minta pin bb atau line atau nomer telfon?
buat sharing sharing aja hehe

Udah di pm ya

danielronaldo23 wrote:

Ilhamwrtm wrote:

danielronaldo23 wrote:Wah enak ya ada yang ngeracunin. Kalau saya ngeracunin diri sendiri. (Lah bunuh diri dong) hehehe

Jangan bunuh diri dong
Boleh minta pin bb atau line atau nomer telfon?
buat sharing sharing aja hehe

Udah di pm ya

oke thanks ya

kamera ini bisa dipasang ke video tx ya kalo gak salah???

denysafari wrote:kamera ini bisa dipasang ke video tx ya kalo gak salah???

Salam kenal om, saya newbie
Ikut menyimak jika suhu suhu ada yang tau

Emang bisa ya? Caranya gimana ya

denysafari wrote:kamera ini bisa dipasang ke video tx ya kalo gak salah???

danielronaldo23 wrote:Emang bisa ya? Caranya gimana ya

iya betul, bisa
itu kan ada mini port jack 3,5mm, kalo di mode video record itu jadi video output, bisa kita colok ke input video sender kan

iwan21 wrote:

denysafari wrote:kamera ini bisa dipasang ke video tx ya kalo gak salah???

danielronaldo23 wrote:Emang bisa ya? Caranya gimana ya

iya betul, bisa
itu kan ada mini port jack 3,5mm, kalo di mode video record itu jadi video output, bisa kita colok ke input video sender kan

Ok saya coba dulu ya om.

iwan21 wrote:iya betul, bisa
itu kan ada mini port jack 3,5mm, kalo di mode video record itu jadi video output, bisa kita colok ke input video sender kan

betul om untuk lebih jelas carnya gini

Procedure for Live video from Wing Camera:

(This is a modified transcription of user MaSu99 review, that I have tried and really works great, so I thought it would be handy to have this file...)

"For all who want to use this camera as FPV-cam while recording - read this!

Normally you won´t get any live view at the TV-OUT while recording but I found out a little trick how it does work:

1 - switch on the camera - wait until it is initialized (long vibration)

2 - set it motion detection video mode (press on/off button twice until yellow and blue leds will be on)

3 - plug in your AV-plug. Wait for a short time until you will see the live view on your Display/TV.

NOTE: ### The following steps must be done very fast, if you do this too slow, the camera will switch off!!!###

4 - pull out your AV-plug

5 - set camera to video mode (press on/off button twice until only blue led will be on)

6 - plug in your AV-plug again (This has to be done very fast, otherwise the camera will switch off!)

7 - Now you can push the record button to start recording while AV-Out gives live view signal for your transmitter."

sory om hasil copy paste masih english

ane punya tapi lum pernah nyoba.