Re: Hitec Aurora 9ch
Posted: 22 May 2011, 21:01
hamster wrote:Ya tambahnya Alaram Buzzer,...tit...tit...tit
mantab ya HITEC...
gampang gak mas up datenya?
gampang gak mas up datenya?
Page 3 of 17
gampang gak mas up datenya?
Re: Hitec Aurora 9ch
Posted: 23 May 2011, 11:19
Praktis & empty setings...tp RX cloningnya udah banyak lum ya ?
Re: Hitec Aurora 9ch
Posted: 24 May 2011, 17:53
Pitra Ratulangi wrote:Praktis & empty setings...tp RX cloningnya udah banyak lum ya ?
rx dah banyak Om, lebih murah lagi dibandingkan pesaingnya........
Re: Hitec Aurora 9ch
Posted: 25 May 2011, 09:47
hulmannapit wrote:Pitra Ratulangi wrote:Praktis & empty setings...tp RX cloningnya udah banyak lum ya ?
rx dah banyak Om, lebih murah lagi dibandingkan pesaingnya........
ah gawat komporrrrrr. om Hulman....wkwkwkwkwkw..:..bs2 proyek 12 CH di kembali ke 9 CH lg nich...hihihihihk..
Re: Hitec Aurora 9ch
Posted: 25 May 2011, 09:53
....mungkin 9 ch dah cukup ya ?????? (throttle-elev-rudder-aileron-flap-airbrake/spoiler-retrack dan 2 ch sisa ) , kalo mo ga bingung , ya tugasnya di bagi 2 , pilot dan operator (sensor)....
Re: Hitec Aurora 9ch
Posted: 25 May 2011, 10:00
pa'de NF ini saya coba angkat saran untuk 2ch apakah jadinya sisa atau kurang ya
1. Elevator
2. Rudder
3. Throttle
4. Aileron 1
5. Aileron 2
6. Flap
7. Gyro gain (for aileron)
8. Turbine or Multi Engine system management control
9. Brakes
10. Steering or Landing Gear Retract Control
11. Smoke
12. Powerbox failsafe
13. Navigation lights
14. Camera
15. Smoke system
16. Temperature, Fuel level and Battery level sensors
17. TBD .....
18. TBD .....
salam
1. Elevator
2. Rudder
3. Throttle
4. Aileron 1
5. Aileron 2
6. Flap
7. Gyro gain (for aileron)
8. Turbine or Multi Engine system management control
9. Brakes
10. Steering or Landing Gear Retract Control
11. Smoke
12. Powerbox failsafe
13. Navigation lights
14. Camera
15. Smoke system
16. Temperature, Fuel level and Battery level sensors
17. TBD .....
18. TBD .....
salam
Re: Hitec Aurora 9ch
Posted: 25 May 2011, 12:42
rx nya murah meriah om pitra....
udh bnyak yg jual jg di indo...setau saya ada 2hs yg jual.
rx 6ch cuma 400rban,7ch cma 500rbuan dan 9ch 700rbuan muarh kan,,,semua full range,rx 7dan 9ch udh dilengkapi telemetry...
hmmm...maknyuss pokoke...
udh bnyak yg jual jg di indo...setau saya ada 2hs yg jual.
rx 6ch cuma 400rban,7ch cma 500rbuan dan 9ch 700rbuan muarh kan,,,semua full range,rx 7dan 9ch udh dilengkapi telemetry...
hmmm...maknyuss pokoke...
Re: Hitec Aurora 9ch
Posted: 25 May 2011, 12:47
jarest wrote:rx nya murah meriah om pitra....
udh bnyak yg jual jg di indo...setau saya ada 2hs yg jual.
rx 6ch cuma 400rban,7ch cma 500rbuan dan 9ch 700rbuan muarh kan,,,semua full range,rx 7dan 9ch udh dilengkapi telemetry...
hmmm...maknyuss pokoke...
alamak..kompore tambah kadarnya nich.....
Re: Hitec Aurora 9ch
Posted: 28 May 2011, 22:06
What's New in Firmware Version 1.08 (View Version 1.08 Manual Addendum)
Added Functions:
1. Frequency check: You can now decide if you want the radio to ask you to confirm your model to transmit.
2. Receiver Battery Low Voltage Warning Function: You can select the Low Battery Warning Alarm activation level.
3. Volt sensor screen for use with "E" Sensor Station.
4. Current sensor screen for use with "E" Sensor Station.
5. Rudder -> Elevator: Now added for knife edge flight and includes the "Adjust function" feature for easy in flight fine tuning
6. Travel Limit: Allows a master EPA to be set so that no matter what mixes influence the servos, so they will not overdriven.
Improved Functions
1. Battery Warning setting Function for telemetry: The Low Battery warning screen is now accessible even when receiver is not on.
2. Aileron Differential: Simplified with single setting added for basic set up
3. Camber Mix: Improved functionality and flexibility
4. New Larger timers for easier monitoring
5. EZ View telemetry monitoring: New screens offer larger text on telemetry functions like Speed, Altitude, RPM, and temp with recorder maximums on all but RPM.
Other Improvements
1. When Throttle lock is activated by the toggle switch, the Touch lock function (Throttle lock by touch screen) will not be available and screen now shows throttle lock status.
2. When a specific model is reset, the model name & model type will remain while the model data will be set back to factory default.
3. Warning at start-up (Check frequency, High Throttle, Abnormal Flight condition warning) can be applied to all models at the same time.
4. The B-Fly (Butterfly/Crow) function has been improved. The servo movement has been increased for more travel without the use of the adjust function setting.
5. Flap-Control function has been improved. "Flaps up" will correspond with the slider or switch in the up positions, "Flaps down" will correspond with the slider or switch in the down position. (Opposite to V1.07 or earlier.)
6. "Speed" of motor control on Servo monitor screen has been normalized when the RF is off.
7. By pressing the "Exit Icon" (door icon) for 2 sec., the screen will return to the home screen. This saves having to hit the icon multiple times to back out of a menu.
8. Models will scroll in groups of 4 ( one page.) Currently, scrolling is one by one.
9. The EXPO has been modified to be more aggressive for more precise control when flying with high/3D control surface throws.
To get full use of your updated Aurora 9 you must also upgrade the Spectra 2.4 Module and Optima 7 & 9 Receivers to Firmware version 2.0
Added Functions:
1. Frequency check: You can now decide if you want the radio to ask you to confirm your model to transmit.
2. Receiver Battery Low Voltage Warning Function: You can select the Low Battery Warning Alarm activation level.
3. Volt sensor screen for use with "E" Sensor Station.
4. Current sensor screen for use with "E" Sensor Station.
5. Rudder -> Elevator: Now added for knife edge flight and includes the "Adjust function" feature for easy in flight fine tuning
6. Travel Limit: Allows a master EPA to be set so that no matter what mixes influence the servos, so they will not overdriven.
Improved Functions
1. Battery Warning setting Function for telemetry: The Low Battery warning screen is now accessible even when receiver is not on.
2. Aileron Differential: Simplified with single setting added for basic set up
3. Camber Mix: Improved functionality and flexibility
4. New Larger timers for easier monitoring
5. EZ View telemetry monitoring: New screens offer larger text on telemetry functions like Speed, Altitude, RPM, and temp with recorder maximums on all but RPM.
Other Improvements
1. When Throttle lock is activated by the toggle switch, the Touch lock function (Throttle lock by touch screen) will not be available and screen now shows throttle lock status.
2. When a specific model is reset, the model name & model type will remain while the model data will be set back to factory default.
3. Warning at start-up (Check frequency, High Throttle, Abnormal Flight condition warning) can be applied to all models at the same time.
4. The B-Fly (Butterfly/Crow) function has been improved. The servo movement has been increased for more travel without the use of the adjust function setting.
5. Flap-Control function has been improved. "Flaps up" will correspond with the slider or switch in the up positions, "Flaps down" will correspond with the slider or switch in the down position. (Opposite to V1.07 or earlier.)
6. "Speed" of motor control on Servo monitor screen has been normalized when the RF is off.
7. By pressing the "Exit Icon" (door icon) for 2 sec., the screen will return to the home screen. This saves having to hit the icon multiple times to back out of a menu.
8. Models will scroll in groups of 4 ( one page.) Currently, scrolling is one by one.
9. The EXPO has been modified to be more aggressive for more precise control when flying with high/3D control surface throws.
To get full use of your updated Aurora 9 you must also upgrade the Spectra 2.4 Module and Optima 7 & 9 Receivers to Firmware version 2.0
Re: Hitec Aurora 9ch
Posted: 30 May 2011, 11:09
Sy udah pake Tx ini selama 3 Bulan dan selama ini tidak ada masalah, setingannya sangat mudah (touch screen lagi ). update firmware terakhirnya sih ver 1.0.8. bawaan pabriknya 1.0.7. untuk update software pake hitec HPP-22 harganya 250 rb.
untuk Rx nya sy udah udah coba 6 ch, 7 ch dan 9 ch. semua gak ada masalah sampai dengan saat ini yang jelas untuk melakukan binding thd Tx dan rx nya sangat simpel sekali. trus sy juga sdh coba telemetry sistemnya, kmrn sih beli yang paketnya 1.3 jt yang terdiri dari :
1. GPS sensor
2. RPM sensor 2 unit. ( Optical dan magnetic )
3. Fuel level sensor ada 4 unit
4. Temperatur sensor 4 unit
5. Sensor station 1 unit
pokoknya telemetry systemnya mantap...gak takut kalo heli atau pesawat crash gampang nyarinya tinggal liat kordinatnya udah dapat tuh pesawat
untuk Rx nya sy udah udah coba 6 ch, 7 ch dan 9 ch. semua gak ada masalah sampai dengan saat ini yang jelas untuk melakukan binding thd Tx dan rx nya sangat simpel sekali. trus sy juga sdh coba telemetry sistemnya, kmrn sih beli yang paketnya 1.3 jt yang terdiri dari :
1. GPS sensor
2. RPM sensor 2 unit. ( Optical dan magnetic )
3. Fuel level sensor ada 4 unit
4. Temperatur sensor 4 unit
5. Sensor station 1 unit
pokoknya telemetry systemnya mantap...gak takut kalo heli atau pesawat crash gampang nyarinya tinggal liat kordinatnya udah dapat tuh pesawat