Oooo masalah voltage yah. Bisa minta panduan untuk masalh ini? Forward saja email panduan dari mereka ke sonythan@yahoo.com
Duhh mesti ke lideteves lagi. Nyari waktunya susah. Ada online store gak yah OK ini. Nih toko perasaan dah lama banget yah sejak saya SMP dah belanja di toko ini.
Mainan baru, 3DR Pixhawk
Moderator: aan
- sonythan
- trainee
- Posts: 23
- Joined: 09 Aug 2012, 22:59
- Location: Lippo Karawaci
- Hopatz
- Senior Airman
- Posts: 178
- Joined: 28 May 2009, 18:06
- Location: Jombang
- Contact:
Re: Mainan baru, 3DR Pixhawk
Panduan sederhana kok om.
Saya shared sekalian..
Roger (3drobotics)
May 16 10:27 AM
Hi Nurfat,
Thank you for the pictures, it seems to be the voltage and current pins are swapped, when the vehicle is disarmed it is showing 16.4 A.
Could you try to check these parameters please?
http://copter.ardupilot.com/wiki/arduco ... T_VOLT_PIN
http://copter.ardupilot.com/wiki/arduco ... T_CURR_PIN
With Pixhawk this should be the configuration BATT_VOLT_PIN = 2 and BATT_CURR_PIN = 3, if they are this way (as I think they should) could you try to modify them like this: BATT_VOLT_PIN = 3 and BATT_CURR_PIN = 2. To do this please connect to mission planner or apm planner, go to config/tuning, planner, check advanced view (at bottom right), click config/tuning again, full parameter list, find the parameters, edit them and click on write params.
Saya shared sekalian..
Roger (3drobotics)
May 16 10:27 AM
Hi Nurfat,
Thank you for the pictures, it seems to be the voltage and current pins are swapped, when the vehicle is disarmed it is showing 16.4 A.
Could you try to check these parameters please?
http://copter.ardupilot.com/wiki/arduco ... T_VOLT_PIN
http://copter.ardupilot.com/wiki/arduco ... T_CURR_PIN
With Pixhawk this should be the configuration BATT_VOLT_PIN = 2 and BATT_CURR_PIN = 3, if they are this way (as I think they should) could you try to modify them like this: BATT_VOLT_PIN = 3 and BATT_CURR_PIN = 2. To do this please connect to mission planner or apm planner, go to config/tuning, planner, check advanced view (at bottom right), click config/tuning again, full parameter list, find the parameters, edit them and click on write params.
- Hopatz
- Senior Airman
- Posts: 178
- Joined: 28 May 2009, 18:06
- Location: Jombang
- Contact:
Re: Mainan baru, 3DR Pixhawk
Roger (3drobotics)
May 16 04:34 PM
The power module is sensing the battery connected to itself so I don't think the ESC is affecting this reading, but if you have the power wires of the BECs to the pixhawk it will be good to add the zener diode:
http://copter.ardupilot.com/wiki/common ... _RC_inputs
Regards,
Roger
Tech Support
3D Robotics
May 16 04:34 PM
The power module is sensing the battery connected to itself so I don't think the ESC is affecting this reading, but if you have the power wires of the BECs to the pixhawk it will be good to add the zener diode:
http://copter.ardupilot.com/wiki/common ... _RC_inputs
Regards,
Roger
Tech Support
3D Robotics
- sonythan
- trainee
- Posts: 23
- Joined: 09 Aug 2012, 22:59
- Location: Lippo Karawaci
Re: Mainan baru, 3DR Pixhawk

Thank you pak. Ntar cobain dulu.....senangnya punya teman yang make pixhawk juga

- Hopatz
- Senior Airman
- Posts: 178
- Joined: 28 May 2009, 18:06
- Location: Jombang
- Contact:
Re: Mainan baru, 3DR Pixhawk
Hehe siap.
Btw pak sony, satcount gps klo gps dr 3dr biasanya dapat brp?
Bisa difotokan?
Saya pake neo mentok 10 didepan rumah..
Btw pak sony, satcount gps klo gps dr 3dr biasanya dapat brp?
Bisa difotokan?
Saya pake neo mentok 10 didepan rumah..
- ipin17
- Senior Master Sergeant
- Posts: 629
- Joined: 20 Dec 2008, 14:32
- Location: Tarakan - Kaltim
- Contact:
Re: Mainan baru, 3DR Pixhawk
Banyak om, saya pakai GPS plus compass 3DR kalau outdoor dan cuaca cerah minimal 12 sat, tertinggi 16 sat, dan dapat signal nya cepat sekali, saat pertama kali dinyalakan dalam bbrp detik saja sdh diatas 6 lalu bertambah terus dan terus.....
Kalau cuaca berawan/mendung pasti dapat minimal 6 sat (kebutuhan minimal untuk bisa pakai GPS)
Kalau cuaca berawan/mendung pasti dapat minimal 6 sat (kebutuhan minimal untuk bisa pakai GPS)
- sonythan
- trainee
- Posts: 23
- Joined: 09 Aug 2012, 22:59
- Location: Lippo Karawaci
Re: Mainan baru, 3DR Pixhawk
Saya coba di GPS saya bisa mencapai 12 yang pernah saya lihat. BTW Pixhawk ini sudah ada versi China nya lho. Dengan harga 50% lebih murah.. ck ck ck ck parah juga yah.... tapi look at the bright side -->> hobby kita jadi lebih murah ha ha ha ha 

- sonythan
- trainee
- Posts: 23
- Joined: 09 Aug 2012, 22:59
- Location: Lippo Karawaci
Re: Mainan baru, 3DR Pixhawk
Mau beli module GPS NEO-6M di Hobbyking. Konektor nya pake apa yah itu apakah Hirose DF13?? Sabtu kemarin cari konektor Hirose DF13 di Lindeteves Trade Center (Glodok) muter dari OK dan toko elektronik lainnya tidak ada yang jual konektor ini bahkan mereka bilang ini konektornya halus sekali gak ada yang jual di Glodok??? nah lho beli dimana yah?? masa konektor aja harus beli dari China atau Amerika??? Blum crimping tools nya mahal sekali pake poundsterling. Kebetulan adapon kabel konektor buzzer yang putus pas di ujung konektornya. Bisa ganti pake konektor model futaba cuma sayang board pixhawknya.
BTW NEO-6M itu kalai dilihat dari gambar menggunakan konektor dengan contact sebanyak 4 pin sedangkan pada pixhawk menggunakan 6 pin artinya harus modifikasi konektor kan???
BTW NEO-6M itu kalai dilihat dari gambar menggunakan konektor dengan contact sebanyak 4 pin sedangkan pada pixhawk menggunakan 6 pin artinya harus modifikasi konektor kan???
- Hopatz
- Senior Airman
- Posts: 178
- Joined: 28 May 2009, 18:06
- Location: Jombang
- Contact:
Re: Mainan baru, 3DR Pixhawk
Iya om. Klo saya potong kabel bawaan neo 6m dan disambung df13 bawaan pixhawk..
- rudyWing
- Master Sergeant
- Posts: 417
- Joined: 03 Apr 2008, 07:14
- Location: PGC
- Contact:
Re: Mainan baru, 3DR Pixhawk
Om Hopatz... copternya apakah dipasang jg power module 3DR?