Re: Newbie....dengan niat nekat
Posted: 09 Aug 2012, 21:58

Komunitas Aeromodelling Nusantara
https://www.gaero.org/
Product discussion & questions for;
FC 28-12 Brushless Outrunner 1534kv
Chad
2/17/2011
Description says will take a 4S at 14.8v .. I've tried running with a 7x6 prop at 4S.. and motor overheats and dies. Did I just have a defective motor? Is there a prop setup that it will run on a 4S? If not, any suggestions on an alternative motor this size that will run a 4S?
Give Chad a point.
-Reply from Waltudes ;
I belive that overload current to the motor... try test any smaller propeller... you can rewinding the motor: can be great. Search the appropiete copper wire.
Give Waltudes a point.
-Reply from simon ;
mmmm it says 7x6 with a 3s battery will give about 700 grams thrust a 4s with 7x6 will kill this motor as you found, you need to reduce the prop size! if you increase the volts from 11.1 to 14.8 you are trying to spin that prop 25 faster which will increase the draw amps beyond a 7x6 on 3s which draws about 15 amps and 700 grms thrust you can put 5x5 on 4s and you may get the same thrust !!!!!
Give simon a point.
-Reply from Etto_S. ;
i saw, the description is wrong... do not use with 4s or loose it. the frame cames with a description - to 11,1v it means 3s in max
dst ... dapat dibaca di http://www.hobbyking.com/hobbycity/stor ... oduct=5423
Wind Raider wrote:Lalalalaalala ... riang ria naik perahu ....
Jiwa manis indung disayang ....
Kira2 begitulah perasan Om Yuehan ..![]()
Congrats ya ...
KBSantoso wrote:Saya jadi kepengen bikin aliran coro, bikinnya simple...lebih mudah dari foam.
Om WR ada plan coro yg midwing/low wing? WS sekitar 120cm...
Saya ada stok motor Power HD 2830, ESC Dynam 40A, servo 5 biji.
Wind Raider wrote:Lalalalaalala ... riang ria naik perahu ....
Jiwa manis indung disayang ....
Kira2 begitulah perasan Om Yuehan ..![]()
Congrats ya ...